Step 1/ Calculation of Braking Power Required.
Based on motor size and the percentage
of the full motor torque required
to stop the load, select the Braking Power required from the table below.
Step 2/ Selection
of Appropriate Unit.
¨
The
resistors DBR*-**R can be selected using the charts below.
¨
Plot
across from the Braking Power you have selected from the table above
to the appropriate duty cycle.
¨
If
deceleration time exceeds 10 seconds duty cycle should be taken as continuous
¨
Select
the module whose Characteristic lies above the point plotted
¨
Special
resistors can be supplied for any duty, Please call or email for details.
If
point lies outside curve of largest unit or you are in any doubt,
Please Call (07092 242773) or email mark@mlhservices.co.uk
Email Us For More Information:
mailto:mark@mlhservices.co.uk
